Fluke 753 Documenting Process Calibrator

  • Fluke 753 Documenting Process Calibrator

Fluke 753 calibrators provides simultaneous source and measure volts, mA, thermocouples, RTDs, frequency, ohms and pressure to calibrate transmitters. It can power transmitters during test, using loop supply with simultaneous mA measurement; measure/source pressure; create and run automated as-found/as-left procedures to satisfy quality programs or regulations; record and document results. Holds up to a full week of downloaded procedures and calibration results. Features include autostep, custom units, user entered values during test, one-point and two-point switch testing, square root DP flow testing, programmable measurement delay etc.

Related Products

Beamex MC6 Multifunction Calibrator SIRIM Certified -K2

Beamex MC6 Multifunction Calibrator SIRIM Certified -K2

NATA certified MC6 provides calibration capability for pressure, temperature, electrical and frequency signals with HART communication and D..

Fitting Set With 20Bar Hose

Fitting Set With 20Bar Hose

Fitting set (max pressure = 10,000psi) for pressure calibrators. Female connector sizes:- 1/4"BSP & NPT; 1/8"BSP & NPT; 3/8"BSP &..

Druck DPI 611-20-NATA 20 bar Pressure Calibrator

Druck DPI 611-20-NATA 20 bar Pressure Calibrator

Fully self-contained pressure test and calibration system combines pressure generation, signal measurement and loop power. Generates from..

Emerson AMS Trex Device Communicator -LF

Emerson AMS Trex Device Communicator -LF

The Emerson AMS Trex is an intrinsically safe HART and Foundation Fieldbus device communicator. It allows technicians to configure, isola..

Tags: calibration, document process, fluke