Your cart is empty!
Fluke 754 with HART offers simultaneous source and measure capabilities for all common process parameters. Measure/source volts, mA, RTDs, thermocouples, frequency, and ohms for the calibration, maintenance, and troubleshooting of test sensors, transmitters and other instruments. Compatible with all Fluke 700Pxx pressure modules. Create and run automated as-found/as-left procedures to satisfy quality programs or regulations. Features include autostep, custom units, user entered values during test, one-point and two-point switch testing, square root DP flow testing, programmable measurement delay etc.
Intrinsically safe HART device communicator. Allows technicians to configure, isolate, diagnose and repair problems while devices continue t..
Provides up to 700 Bar hydraulic, 40 Bar pneumatic pressures and vacuum to -950 mBar. Built-in stroke adjuster, lower pressure fine contr..
Measure 4-20 mA control lines, PLC loops, transmitters or any 4-20 mA line without breaking the loop. Capable of 0-20.99 mA and 24-100 mA..
NATA certified MC6 provides calibration capability for pressure, temperature, electrical and frequency signals. HART communication and CM..
Tags: fluke, hart, process calibrator