Hioki 3285 AC/DC Clamp-on Meter with Analog Output

  • Hioki 3285 AC/DC Clamp-on Meter with Analog Output

Ranges 200A/2kA AC/DC. Measure volts, ranges 30V, 300V & 600V AC/DC. Frequency ranges 10Hz, 100Hz & 1kHz. Display LCD, counts max 2,500 current, 3,750 voltage and 1,250 frequency. Output voltage 1V for 2,000 count fs for each current range, can select Rec RMS output, response time about 250ms rise time, fall about 500ms. Waveform output. 1V is produced for 1,000 count on full scale frequency range. Output not available for voltage measurements. Supplied with signal output cord, 4mm to BNC convertor, carry case and AC adaptor. Powered with internal 9V battery or AC adaptor. (AC adaptor not supplied).

Related Products

Hioki 9694 Clamp-on CT 5A

Hioki 9694 Clamp-on CT 5A

Rated primary current 5A AC. Amplitude accuracy +/-0.5% rdg. +/-0.2% fs (at 45 to 66Hz), 66Hz to 5kHz +/-1% or less. Max circuit voltage ..

Fluke i5sPQ3 ac Current Clamps, 5 A (3 x i5S per set)

Fluke i5sPQ3 ac Current Clamps, 5 A (3 x i5S per set)

A pack of 3 pieces of the i5s 5 A ac current clamps, specially configured to provide low current accuracy while taking measurements on se..

Fluke 90I-610S 1 A to 600 A ac/dc Current Probe

Fluke 90I-610S 1 A to 600 A ac/dc Current Probe

Compatible with any Fluke scopemeter test tool, power harmonics analyser, oscilloscope, multimeter or other voltage measurement device th..

Dranetz TR2510 10A clamp-on CT (set of 4)

Dranetz TR2510 10A clamp-on CT (set of 4)

Set of 4 current clamp/probes, range 0 to 10A RMS. Max conductor size 12mm dia. Suitable for power quality analysers DRA-BMI,PG4400, DRA-..

Tags: 3285, ac/dc, analog output, clamp-on meter