Your cart is empty!
Fluke 753 calibrators provides simultaneous source and measure volts, mA, thermocouples, RTDs, frequency, ohms and pressure to calibrate transmitters. It can power transmitters during test, using loop supply with simultaneous mA measurement; measure/source pressure; create and run automated as-found/as-left procedures to satisfy quality programs or regulations; record and document results. Holds up to a full week of downloaded procedures and calibration results. Features include autostep, custom units, user entered values during test, one-point and two-point switch testing, square root DP flow testing, programmable measurement delay etc.
Intrinsically safe HART device communicator. Allows technicians to configure, isolate, diagnose and repair problems while devices continue t..
Fully self-contained pressure test and calibration system combines pressure generation, signal measurement and loop power. Generates from..
Precision Multifunction Process Calibrator. DC voltage msmt. 0.010% 30 V max, source 0.010% 20 V max. DC current msmt. 0.010% 24 mA max, ..
The PROFIBUS Tester 5 (BC-700-PB) is a powerful diagnostic and troubleshooting tool for testing cables, measuring signals and analysing the ..
Tags: calibration, document process, fluke