Your cart is empty!
Fluke 754 with HART offers simultaneous source and measure capabilities for all common process parameters. Measure/source volts, mA, RTDs, thermocouples, frequency, and ohms for the calibration, maintenance, and troubleshooting of test sensors, transmitters and other instruments. Compatible with all Fluke 700Pxx pressure modules. Create and run automated as-found/as-left procedures to satisfy quality programs or regulations. Features include autostep, custom units, user entered values during test, one-point and two-point switch testing, square root DP flow testing, programmable measurement delay etc.
Standard multimeter functions with 2 to 20mA sink and source capability, including a 24V supply. HART 250 resistor, 20mA drive into 1,200..
NATA certified MC5-IS provides calibration capability for pressure, temperature, electrical and frequency signals. HART communication and..
Fully self-contained pressure test and calibration system combines pressure generation, signal measurement and loop power. Generates from ..
For use with the Fluke 744 & 725 industrial calibrators. Pneumatic system range 0 to 70Bar, resolution 7mBar, reference uncertainty 0..