Fluke 789 ProcessMeter

  • Fluke 789 ProcessMeter

Standard multimeter functions with 2 to 20mA sink and source capability, including a 24V supply. HART 250 resistor, 20mA drive into 1,200. Simultaneous mA and % of scale readout on mA output. 25% manual step plus auto step and auto ramp on mA output. Min/max/average/hold/relative modes. Double size dual display. Accuracy, VDC 0.1% +1, VAC 0.7% +2, mA DC 0.05% +2, frequency 0.005% +1.

Related Products

Druck DPI 611-20-NATA 20 bar Pressure Calibrator

Druck DPI 611-20-NATA 20 bar Pressure Calibrator

Fully self-contained pressure test and calibration system combines pressure generation, signal measurement and loop power. Generates from..

Emerson 475 HART and FF communicator

Emerson 475 HART and FF communicator

Will configure, test, and diagnose your HART and Foundation FieldBus devices. Able to communicate with any device, by any manufacturer. I..

Emerson AMS Trex Device Communicator -LF

Emerson AMS Trex Device Communicator -LF

The Emerson AMS Trex is an intrinsically safe HART and Foundation Fieldbus device communicator. It allows technicians to configure, isola..

Emerson AMS Trex Device Communicator with HART

Emerson AMS Trex Device Communicator with HART

Intrinsically safe HART device communicator. Allows technicians to configure, isolate, diagnose and repair problems while devices continue t..

Tags: fluke 789, fluke 789 process meter, process meter, multimeter